top of page
Commercial
Perry 57
Full scan and model of entire vessel for the builder and naval architect
Shark Cat
8m alloy catamaran scanned and hull model created for hydrostatic analysis
Launching simulation
Scan of slipway for launching Perry 57
Damage repair
Scan of damaged hull
for new fibreglass structure and laminate
DMS Direct Marine Solutions
Model making
Vintage boat scanned for development of a scale model for Regatta Marine
Super yacht refit
Benetti flybridge scanned and modelled for new fit out
Oceanic Yacht Design
Hull extension
Steel hulled motor yacht
scanned and modelled for hull extension and hydrostatic analysis.
Aus Ships
Documentation
Mould of workboat scanned in situ to create lines plan and CAD drawings
IMO compliance
Golden Globe Race sailboat fully scanned.
The data file was converted to a web based ".lgs" format for private client web portal
1:10 scale model
Full exterior scan of new catamaran with mesh surfaces generated for five axis CNC milling and model making.
design by Andrew McDonald-Smith
Geometry check
Scan and model of power catamaran hull to check symmetry of hulls for sea keeping
Sea Transport
Seadek installation
The sole of a tender was scanned with the proposed shapes defined by (green) masking tape. These areas were then transferred to a CAD program and non-skid Seadek foam was CNC cut and applied by O'Neill Shipwrights
Interior refit
The exterior, maindeck and saloon of superyacht Dynasty was scanned and a mesh model was created in order to design a new interior arrangement. 2D drawings created from projected lines
Ocean Degree
Nozzle redesign for fishing boat
The existing nozzle was scanned with the Leica RTC360 and the shaft position recorded with the Leica TCR703. This information was used to create a precise CAD surface model.
Aurora Marine Design
15m sailboat stability
Scan of sailboat for stability assessment.
(Green spheres represent scan positions)
Brisbane city cross river ferry
This hull was modelled using data from the RTC360 and the TCR703 for a comparative study. (Dots are from TCR703, point cloud is from RTC360)
Boat of the week !
"Wyn Joy"
Classic plywood runabout ready for full restoration
Scimitar power catamaran
10 m Scimitar moulds and parts scanned for mould modifications and construction drawings
Aus Ships
Claas Oldendorff bulk iron ore carrier
Engine room scan. Images of raw point clouds and Recap illustrations.
The interior and exterior
of the engine room of a bulk carrier was scanned for naval architects IHB Ship Design (Bulgaria)for retrofitting an exhaust scrubber system.
479 scans completed in 3 days while vessel was anchored at Port Hedland, Western Australia
75 ft Sunseeker with mocked up transom and sunshade. Scanned for naval architects, Oceanic Yacht Design
100 ft Horizon "Elysium" Fully scanned for new targa design. Visual representation enabled owner's feedback during design phase. Construction by Signature Yacht Services
Inboard engine conversion Hull and deck moulds were scanned and new structure was formed using 3D CAD.
A "plug" of the new part was then CNC routed, followed by the production of a new mould.
Stejcraft Boats
Restoration
Pearling lugger built in 1907.
A full interior and exterior scan of the timber structure was conducted at the Queensland Maritime Museum for stability analysis and engineering by Norman R. Wright & Sons
Read the story here
Party Boat
This vessel was built on the hulls of an unfinished sailing trimaran.
After arriving from Hawaii, the hull geometry was scanned (using the TCR703 scanner). Aurora Marine Design then miraculously transformed this orphaned bare boat into the elegant and iconic YOTCLUB
Aluminium workboat
This vessel was scanned to produce a stability model to ensure compliance with AMSA regulations after a change of ownership. Scan was conducted while the vessel was blocked up on a barge in the Brisbane River.
Aurora Marine Design
bottom of page